EASY STEP-BY-STEP INSTRUCTIONS ON HOW TO APPLY YOUR IRON-ON

























1. TRIM

TRIM THE EXCESS IRON-ON
MATERIAL AROUND THE
IMAGE.



2. SURFACE PREPARATION

A. USE A HARD, HEAT RESISTANT SURFACE.

B. DO NOT USE AN IRONING BOARD.

C. SET A COTTON PILLOWCASE ON A HARD
SURFACE AND LAY GARMENT ON TOP.

D. SET IRON FOR NO STEAM.
IRON SHOULD NOT HAVE WATER.

E. SET IRON TO HIGH OR COTTON SETTING.

F. IRON THE PILLOWCASE AND GARMENT TO
REMOVE ALL WRINKLES.



3. PREPARING THE IRON-ON

NOTE THAT THERE ARE TWO PARTS
TO THE IRON-ON: THE IRON-ON SHEET
AND THE PAPER BACKING. PEEL OFF AND
REMOVE THE PAPER BACKING FROM THE
IRON-ON, STARTING FROM THE CORNER.



4. IRON IRON-ON ONTO GARMENT

A. PLACE IRON-ON WITH PRINTED IMAGE
FACING UP ONTO GARMENT.

B. COVER THE IRON-ON WITH THE TISSUE
PAPER PROVIDED.

C. IRON IRON-ON IN SECTIONS USING
FIRM PRESSURE.

D. EVENLY IRON IRON-ON TO MAKE SURE
ALL AREAS ARE COVERED.



















5. IRONING TIME

A. FULL SHEET = 2 MINUTES.

B. 3/4 SHEET = 1 1/2 MINUTES.

C. 1/2 SHEET = 1 MINUTE.

D. 1/4 SHEET = 40 SECONDS.




6. COOL DOWN

REMOVE GARMENT FROM HEATING
AREA AND ALLOW IRON-ON TO COOL
FOR ABOUT 2-3 MINUTES.




7. PEEL

PEEL AWAY IRONING TISSUE IN A
SMOOTH, EVEN MOTION.



8. WASH

WAIT AT LEAST 24 HOURS BEFORE
WASHING OR WEARING YOUR GARMENT.
TO PROLONG THE VIBRANCY OF THE
TRANSFER, WASH GARMENT INSIDE OUT
IN COLD WATER AND DO NOT USE BLEACH.
REMOVE GARMENT AS SOON AS THE
WASH CYCLE IS COMPLETE. LAY FLAT TO
DRY. IT IS NOT RECOMMENDED TO PLACE
ITEM IN DRYER. IF IRONING FABRIC IS
DESIRED, DO NOT IRON DIRECTLY ON TRANSFER.



EIRONONS REWARDS    

THE COOKIE SETTINGS ON THIS WEBSITE "JUFODE.COM" ARE SET TO "ALLOW ALL COOKIES" TO GIVE YOU THE VERY BEST EXPERIENCE. PLEASE CLICK THE "ACCEPT COOKIES" BUTTON BELOW TO CONTINUE TO USE "JUFODE.COM".